Safety Warnings - Astralpool 35275 Manuel D'installation

Colorplus ECO diagram
Power supply
Mini LED
projectors
Both the Modulator (27818) and the pushbutton (32458) control a maximum of 100 MICRO LED Projectors.
In installations with more than one power supply, it is recommended to use the control through the Modulator instead of the
pushbutton, as the receiver sends signals periodically and therefore the power supplies do not lose synchronism when
operating for hours in sequence. The pushbutton, on the other hand, is a passive element which only sends one signal.
7. MAINTENANCE:
This projector does not require any type of maintenance. If the projector is not working properly, please contact our
customer attention department.
The inside of the projector should not be handled under any circumstances, as this would lead to losing the guarantee.
Attention: Before any handling ensure that there is NO voltage supplied to the floodlamp.

8. SAFETY WARNINGS:

• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS
• All maintenance operations should be performed with the projector disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.
7