Milwaukee SUPER SAWZALL 6537-22 Manuel De L'utilisateur page 8

TWO YEAR TOOL LIMITED WARRANTY
Every MILWAUKEE tool is tested before leaving the factory and is
warranted to be free from defects in material and workmanship.
MILWAUKEE will repair or replace (at MILWAUKEE 's discretion), with-
out charge, any tool (including battery chargers) which examination
proves to be defective in material or workmanship from two (2) years
after the date of purchase. Return the tool and a copy of the purchase
receipt or other proof of purchase to a MILWAUKEE Factory Service/
Sales Support Branch location or MILWAUKEE Authorized Service Sta-
tion, freight prepaid and insured. This warranty does not cover damage
from repairs made or attempted by other than MILWAUKEE authorized
personnel, abuse, normal wear and tear, lack of maintenance, or
accidents.
Battery Packs, Flashlights, and Radios are warranted for one (1) year
from the date of purchase.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE
EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING
LOSS OF PROFITS.
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRAN-
TIES, OR CONDITIONS, WRITTEN OR ORAL, EXPRESSED OR IMPLIED FOR
MERCHANTABLILITY OR FITNESS FOR PARTICULAR USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have other
rights that vary from state to state and province to province. In those
states that do not allow the exclusion of implied warranties or limitation
of incidental or consequential damages, the above limitations or exclu-
sions may not apply to you. This warranty applies to the United States,
Canada, and Mexico only.
page 8
ACCESSORIES
To reduce the risk of injury, always unplug the
tool before attaching or removing accessories.
Use only specifically recommended accesso-
ries. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric
Tool catalog or go on-line to www.mil-electric-tool.com. To obtain a cata-
log, contact your local distributor or a service center listed on the back
cover of this operator's manual.
Quik-Lok ® Cord Sets
®
8' Quik-Lok Cord
Cat. No. 48-76-4008
25' Quik-Lok ® Cord
Cat. No. 48-76-4025
Offset Blade Adapter
Select Models (Fig. 7)
Cat. No. 48-03-2010
An offset blade adapter is available to make flush cuts possible. To
attach, remove blade clamping screw and blade clamp. Place adapter
over spindle, lining up hole in adapter casting with threaded hole in
spindle. Replace screw, attaching adapter to spindle. Blade can then
be secured in adapter blade clamp in the same manner it was secured in
the spindle clamp.
Fig. 7
Select Models:
Blade Clamp
Cat. No. 42-68-0647
Blade Clamp Screw
Cat. No. 06-83-2960
"787" Blades:
Blade Clamp
Cat. No. 42-68-0677
Blade Clamp Screw
Cat. No. 06-83-2960
WARNING!