Metrix MTX 1032-B Notice De Fonctionnement page 10

English
General instructions (continued)
Warranty (cont'd) The warranty does not apply in the event of:
•
unsuitable use of the equipment or use with other incompatible equipment
•
modification of the equipment without the explicit authorization of the
manufacturer's technical services
•
repair carried out by a person not certified by the manufacturer
•
adaptation for a specific application, not included in the definition of the
equipment or the user's manual
•
an impact, a fall or flooding.
Maintenance and Information and contact details : your nearest distributor.
metrology
Symbols Warning: Risk of danger. Refer to the operating manual.
used
Earth
All the equipment was verified mechanically and electrically before shipping.
Unpacking -
Repacking
When you receive it, carry out a quick check to detect any damage that may
have occurred during transport. If necessary, contact our sales department
immediately and register any legal reservations with the carrier.
In the event of reshipping, it is preferable to use the original package. Indicate
the reasons for the return as clearly as possible in a note attached to the
equipment.
Fastening the probe The fittings to fasten the probe to the MTX oscilloscope are located
inside the probe unit.
to the oscilloscope
Assembly procedure 1. Turn the probe over.
2. Unscrew the base.
3. 4 screws and 4 spacers are
located in one of the two
housings inside the unit.
4. Remove the 4 oscilloscope feet.
5. Take the protective caps off the 4
corners of the probe and insert the
spacers.
6. Assemble the probe and
oscilloscope with the fittings.
7. Screw the base of the probe back
on.
•
Disconnect all the measurement leads.
Cleaning
•
Turn the instrument off.
•
Clean it with a damp cloth and soap.
•
Never use abrasive products or solvents.
•
Allow to dry before any further use.
MTX 1032-B - MTX 1032-C
9