Ndustrio 191PD1G Manuel D'utilisation Et D'installation page 42

CONVERSION OF GAS SUPPLY
The constructor has tested the appliance with its
own mains gas, identified by the sticker applied to
the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
1 - Turn off the gas supply tap (A).
2 - Change the burner nozzle (see page 21)
3 - Change the pilot light nozzle (see page 22)
4 - Adjust the minimum setting on the gas control
valve (see page 19)
5 - If necessary, adjust the burner primary air (see
page 20).
6 - Remove the sticker from the nameplate and ap-
ply the new one to identify the gas being used.
Important
On completion of the operation, make
sure that there are no gas leaks or mal-
functions.
IT
TESTING OF THE APPLIANCE
GB
Important
Before it is put into service, the system
DE
must be tested to check the operating con-
ditions of every single component and
identify any malfunctions. In this stage, it is
FR
important to check that all health and safety
requirements have been complied with in
ES
full.
To test the system, make the following checks.
1 - Turn on the gas supply tap and check that the
connections are right.
2 - Check that the mains gas is the same as that
used for commissioning of the appliance, and
carry out the conversion procedure if necessary
(see page 18)
Check that the burner is switching on correctly
and its combustion.
English
A
3 - Check the gas pressure and flow-rate at mini-
mum and maximum settings and adjust if nec-
essary (see page 11)
4 - Check that the safety thermocouple is working
correctly.
5 - Check that there are no gas leaks.
6 - Check that the nameplates specify the correct
gas for the country of use.
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.
- 18 -
IDM-39614601700.tif
IDM-3960200250.tif