Beta 1885 Notice D'utilisation Et Instructions page 16

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
- Always disconnect the automatic transmission cleaning station before checking it for failures or cleaning it: this precaution will
prevent the station from being accidentally started, thereby ensuring safety during use.
AUTOMATIC TRANSMISSION CLEANING STATION USE AND CARE
- Do not use the automatic transmission cleaning station if it has been damaged.
- Do not modify the automatic transmission cleaning station. This can reduce the effectiveness of safety measures and increase
operator risk.
- Have the automatic transmission cleaning station repaired only through a trained person and only using original replacement
parts.
- Do not use the automatic transmission cleaning station with any voltages other than those stated in the TECHNICAL DATA table.
- To clean the automatic transmission cleaning station, use a dry cloth. Always disconnect the automatic transmission cleaning
station from the power supply mains before cleaning it. Never use damp or wet cloths.
- Do not place the station horizontally, because oil would leak.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING AUTOMATIC TRANSMISSION
CLEANING STATION
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AND CHEMICAL
AGENTS WHILE OPERATING AUTOMATIC TRANSMISSION CLEANING STATION
WEAR A PROTECTIVE MASK AGAINST PHYSICAL AGENTS
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey may be required if the values exceed the limits under current regulations.
TECHNICAL DATA
NOMINAL POWER SUPPLY VOLTAGE
ELECTRIC PUMP – MAX. PRESSURE
ELECTRIC PUMP - MAX. FLOW RATE
FILTERING EFFICIENCY
OIL TANK N°. 2
OPERATING TEMPERATURE
DIMENSIONS
WEIGHT
EQUIPMENT SUPPLIED WITH AUTOMATIC TRANSMISSION CLEANING STATION
The automatic transmission cleaning station is always supplied with comprehensive, top-quality equipment:
- 1 delivery pipe (figure 1)
- 1 return pipe (figure 1)
- 1 fittings kit (figure 2)
OPTIONAL FITTINGS (www.beta-tools.com)
16
230V – 50Hz
16 bar
14l/min
10 microns
20l/each.
-20 °C ÷ +60 °C
520x650x1000 mm
78 kg
EN I