Monacor JTS R-4THA/5 Mode D'emploi page 10

Fig. 1 Menu
SET (2 s)
Group
SET
Channel
SET
MHz
SET
MHz
SET
Sensitivity
−15 dB...15 dB
SET
RF Power
High – Low
SET
ID No.
SET
Sync REMOSET
On – OFF
SET
Exit
Overview
1 Display, see chapter 3 3, fig 3 for details
2 LED indicator:
lights up in green = microphone switched on
flashes in green = microphone muted
lights up in red = batteries discharged
lights up in blue = settings are being transferred
from the receiver to the microphone by means
of the REMOSET function
3 Sliding switch to mute the microphone
4 Screw sleeve; when it is screwed off, the control
buttons (7 – 9) and the battery compartment
(10) are accessible
5 Button to switch the microphone on / off and
to show the ID number for the REMOSET func-
tion
To switch off the microphone, keep the button
pressed for 2 seconds until
the display
10
1
2
3
MUTE
4
5
6
is shown on
OFF
Fig. 2 R-4THA / 5
MUTE
7
8
SET
9 10
11
6 Cap to mark the microphone when multiple
microphones are used at the place of operation:
The cap can be replaced by one of the colour
caps provided
7 Button SET to call up the menu (fig 1): Keep
the button pressed for 2 seconds until SEtUP
is briefly shown on the display
8 Button to activate the key lock function:
Keep the button pressed for 2 seconds until
is shown on the display
To deactivate the key lock function, keep the
button pressed for 2 seconds until
guishes
9 Buttons and

menu
10 Battery compartment
11 Battery holder; to replace the batteries, open the
battery holder (pull hard to disengage the holder)
to change settings via the

extin-