Description
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Select a suitable place for the device, taking into account the safety instructions. The
WH2000C has to be hung from a wall and therefore may not be used in a lying,
leaning, hanging or standing position! The wall on which the device is hung has to be
firm, flat and perfectly vertical and made from non-inflammable material that cannot
melt. De zijkanten en bovenkant van het apparaat moeten minstens 20 cm. verwijderd
zijn van zijwanden en plafond, en de bovenzijde moet zich minimaal 180 cm. boven de
grond bevinden.
The heater has to preferably be positioned at and permanently connected to an
electric socket. This connection may only be made by a qualified electrician and, for
that reason, is not described here.
In this booklet, for reasons of safety, use with a plug should be assumed; when
there is a permanent connection, any passages about the plug do not apply.
1 – Suction grille
2 – Flap with outlet grille
3 – Electrical cable with plug
4 – Display
Display:
6 – Fan symbol
7 – Signal lights
8 – Oscillation symbol
9 – Control button
10 – Timer button
Remote control:
11 – ON/OFF button
12 – Higher button
13 – Mode selection button
14 – Oscillation
15 – Lower
16 – Timer button
17 - CANCEL button
Battery:
battery
15
(MODE)
1 x 3V lithium