Trotec TTK 200 Notice D'utilisation page 16

Commissioning of the apparatus:
1.Insert the apparatus' plug into a correctly-fused
mains socket (230 V/50 Hz).
2. Check that the tank warning lamp is not lit.
3. Press the mains switch so that it is in operating
mode "I" .
4. For dehumidifying operation, set the rotary control
switch to the desired operating level.
The appliance is now operating and working at the
desired dehumidifying level. To switch off the appli-
ance, press the mains switch so that it is in operating
mode "0".
Information on operating the apparatus:
• The appliance works fully automatically after being
switched on until it is switched off by the condensate
tank rocker when the tank is full.
• If the power supply is interrupted during operation,
the apparatus does not automatically switch itself
on again when the power supply is restored.
• I f the apparatus is to be used in continuous operation
with an external condensate connection, please
read the section "Continuous operation with external
condensate connection".
B - 4
• The ventilator runs continually until the apparatus
is switched off so that the sensor built into the ap-
paratus can always correctly determine the air hu-
midity within the room.
Information on first use and the different types of
operation:
When using the dehumidifier for the first time, turn the
rotary control switch to its maximum position. Let the
appliance run for a while in this operating mode. At
the start, the dehumidifier will absorb large quantities
of moisture and will continue to do so until the relative
humidity has been reduced. After that, the appliance
will absorb less moisture. This does not mean that the
dehumidifier is not working properly, but rather that
the humidity of the air has been reduced.
As soon as you notice the pleasant feeling of dryer
air and that the unpleasant odour of damp has dis-
appeared, you can switch the appliance to one of two
different operating modes: hygrostat control or per-
manent operation.
With stepless hygrostat control, you can now set the
rotary control switch to a position between off and
permanent operation, depending on your personal re-
quirements. To automatically maintain the current hu-
midity of the room air, carefully reduce the dehumidi-
fying power by slowly turning the rotary control switch
anticlockwise towards the off position and leaving it
in the exact position where the compressor switches
off. The built-in hygrostat stores the desired relative
humidity value and automatically switches the appli-
ance on or off respectively when the humidity drops
below or exceeds this value, effectively maintaining
the set humidity level.
In permanent operation mode, the appliance de-
humidifies the air continuously, irrespective of the
humidity of the air. For permanent operating mode,
leave the rotary control switch unchanged at its max-
imum position.
Operating Manual – Dehumidifier TTK 200 EN