Zanussi ZRS9600FA Notice D'emploi page 46

How to install Water Line
(Dispenser Models Only)
1. The water pressure should be 2.0~12.5 kgf/cm
more to run the automatic icemaker.
• Checkup your tap water pressure; if a cup of
180 cc is full within 10 seconds, the pressure
is OK.
2. When installing the water tubes, ensure they are not
close to any hot surfaces.
3. The water fi lter only "fi lters" water; it does not
eliminate any bacteria or microbes.
4. If the water pressure is not high enough to run the
icemaker, call the local plumber to get an additional
water pressure pump.
5. The fi lter life depends on the amount of use. We
recommend you replace the fi lter at least once
every 6 months.
• When attaching the fi lter, place it for easy access
(removing & replacing).
6. After installation of refrigerator and water line
system, select [WATER] on your control panel and
press it for 2~3 minutes to supply water into the
water tank and dispense water.
Installation Procedure
(Dispenser Models Only)
1. Join Connector to the tap water line
46
Figure A
Figure B
7. Use sealing tape to every connection of pipes/tubes
to ensure there is no water leak.
8. The water tube should be connected to the cold
2 or
water line.
WATER SUPPLY KIT
Check the parts below for installing water supply. Some
other necessary parts are available at your local service
agents.
Connector
(3014454520)
(7112401211)
(3019974100)
Place the rubber washer inside the tap connector
and screw onto the water tap.
2. Get ready to install the Water Filter
• Measure an approximate distance between the
fi lter and the Water Tube and cut the tube off
fi lter vertically.
• Connect the tubes to the fi lter as the fi gure
shows.
Leave a suffi cient distance when cutting the tubes.
(3012020700)
3011202000
(A:3019503200
B:3019503300)