TESY GCV50L Manuel D'utilisation page 19

To connect the water heater to your
5.
home Wi-Fi network and then to
the Internet, please follow the steps
below:
•
Open the Settings menu from the
main screen
•
from Outdoor control choose Wi-Fi
Scan
•
Select your local wireless Wi-Fi
network and the password that you
use to protect it
•
Upon successful connection (30-40
sec.) you will see the message
"Successful connected to the
Internet!"
Upon successful connection, please proceed with the other settings.
Note: With some models you may need more time to connect. You should wait for few minutes before starting the
procedure from point 5 again.
Note: It is recommended to use WPA or WPA2 encryption, and if your Wi-Fi modem is very old, use WEP
encryption.
Volume setting
6.
You have to set a volume in order for the calculator for consumed
power to operate correctly.
•
Choose from the Settings menu > Volume
•
Choose from the drop down menu > the volume of your water
heater.
Note: The water heater volume is indicated in the type plate on the
appliance.
•
Press the Save button to confirm the settings.
English
EN
19