HQ Power PROMIX902 Mode D'emploi page 2

• Always use the included power supply. The power supply falls under protection class II and the mixing table under
protection class III.
• Do not shake the device and avoid brute force when installing or operating the mixing panel.
• Select a location where the device will not be exposed to water or moisture, excessive heat or dust. Do not leave
any cables lying around.
• Do not use the device under extreme temperatures (> 30°C, < 5°C).
• Keep the device away from heaters.
• Familiarise yourself with the operation of the device before bringing it into service and do not allow operation by
unqualified individuals. Damage is usually caused by unprofessional operation of the device.
• Do not use spray cleaners to clean the faders and do not clean the device with abrasives or solvents. Use a clean
and damp cloth instead.
• Use the original packaging if the device is to be transported.
• Do not attempt to make adjustments or execute repairs. Consult a qualified technician instead.
• Removing the barcode will void the warranty.
• Use only high-quality cables in order to obtain the highest sound quality.
• You should only use the device for the applications described in this manual. Damage caused by unauthorised
use will automatically void the warranty and may lead to electroshocks, burns or short circuits.
• Connecting devices: put the power switch in the OFF position. Make sure the devices in question are also OFF.
Place the master control in the minimum position.
Remember to consult a qualified technician if necessary.
4. Installation and Operation
Connect all the stereo input sources first and connect the microphones and the headphones. Make sure all faders are
placed in their minimum positions ("0"). Connect the stereo outputs to the power amplifier and/or tape decks.
Plug the device into an AC power source.
NOTE: Use shielded low-capacitance stereo cables for the RCA connections. The quality of the cables is essential for
high-quality sound reproduction.
5. Description
a. Front Panel (fig. 1)
PROMIX902
2 VELLEMAN