HQ Power PROMIX902 Mode D'emploi page 3

1. POWER switch:
Press this switch to turn the power on, press again to turn the power off. When turning on or off the mixer, be sure
that all controls are set to minimum position.
2. LED VU meters:
Those LED's indicates the left and right level of the master output.
3. Tone control – DJ MIC:
With these knobs you can change the tone control for the DJ MIC.
Bass, mid and high tones can be controlled separately with these 3 knobs.
4. DJ MIC input:
XLR 3-pin connection for microphone input. This input is also made for a gooseneck microphone.
This input can be used with the VOICE-OVER function.
5. Input selectors:
These buttons are used to select the input signal. You can choose between LINE STEREO and PHONO.
6. GAIN control for channel 1-4:
With these buttons you can choose the level of each channel.
7. HIGH control for channel 1-4:
With these buttons you can change the HIGH tones for each channel.
8. MID control for channel 1-4:
With these buttons you can change the MID tones for each channel.
9. BASS control for channel 1-4:
With these buttons you can change the BASS tones for each channel.
10. Channel level controls 1-4:
With these faders you can adjust the output level of each channel to obtain the desired volume of each channel.
11. GAIN control for channel 5-8:
With these buttons you can choose the level of each channel.
12. HIGH control for channel 5-8:
With these buttons you can change the HIGH tones for each channel.
13. MID control for channel 5-8:
With these buttons you can change the MID tones for each channel.
14. BASS control for channel 5-8:
With these buttons you can change the BASS tones for each channel.
15. Channel level controls 5-8:
With these faders you can adjust the output level of each channel to obtain the desired volume of each channel.
16. Cross-fader selections:
Those switches allow you to select which channels from 1-4 you want to use for A and B of the cross-fader.
17. Cross-fader
With this linear fader you can mix between the 2 selected channels on A and B. You can slide slow or fast.
18. TALK-OVER switch (voice-over):
When this switch is activated, the level of the music will reduce when the microphone is in use.
19. DJ microphone level control:
You can use this button to change the volume of the DJ microphone.
20. OUTPUT MASTER faders:
These faders are used to adjust the output level of master A or B output.
21. Headphone level control:
This knob is used to adjust the volume level of the stereo headphone.
22. Headphone input ¼" jack:
Stereo input jack for headphone (1/4" – 6.35mm).
23. Headphone monitor selector:
The 6-position rotary knob allows you to select the source you want to listen to.
PROMIX902
3 VELLEMAN