Kratki UMBRELLA Instructions D'installation Et D'utilisation page 42

EN
Step 3 i 4. Screw the burner as per diagrams on page 13 and 16.
While installing the UMBRELLA/BS version you must put the high temperature silicone sealings provi-
ded by the manufactured and cut to size, on each glass left side at full length of the glass, to seal the
combustion chamber if the glass chamber would not be preinstalled.
CHOOSING THE LOCATION OF THE GAS OUTDOOR HEATER
The UMBRELLA gas garden heater is a mobile device capable of movement to any place of your choice.
However, there are restrictions that must be strictly followed. The device, due to the possibility of high
temperatures on its external surfaces, should be kept away from flammable materials, and also due to
the open combustion chamber without the possibility of connecting to chimney flues, it should be
used in open spaces or in well-ventilated rooms. IT IS ABSOLUTELY PROHIBITED to place the device in
a position other than vertical.
Tips for proper and safe installation of the device:
• Connect the regulator to a cylinder or a household liquid gas installation, so that the valve does not
affect the horizontal position of the burner together with its other components. Connecting it in any
other way may block the gas supply to the device. To do this, use the appropriate tools. Tightening
the regulator by hand is insufficient and may result in gas leakage. Cylinder replacement and / or
connection should take place in well ventilated areas.
• Make sure that the rubber gaskets are in place and undamaged before connecting the gear unit. If
this is not the case, the device cannot be used until the seal has been replaced.
• Remember that the gas cylinder should always be in an upright position and the hose connecting
the cylinder to the burner should be laid in such a way that it does not come into contact with sharp
objects or edges, as well as hot elements of the burner.
• Check the correctness and tightness of the installed gas control system and the entire gas system of
the device. To do this, you can use soapy water or a dedicated spray to detect gas leaks. To check for
leaks, cover with water and soap or spray any connections (cylinder- reducer, reducer - gas hose, gas
hose - controller gas block, gas block - copper wires for the magnetos and main burner, main burner
nozzle - copper wire) between the cylinder and the controller and those behind the gas block, and
then ignite the device so that the gas also fills the section from the gas block to the burner nozzles.
If bubbles appear on the joints, it means that there is a leak in this place.
ATTENTION: Safe distances from flammable materials that should be observed in accordance
with the instructions in this manual have been established on the basis of safety tests. Flammable
materials can be called anything that can catch fire, i.e. paper, wood, all kinds of fuels, plastic,
clothing, etc. The designated space is not limited by non-flammable materials, but also applies to
flammable materials directly behind non-flammable objects exposed to contact with device.
If you are unsure of the flammability of any material within the device, consult your fire brigade.
Remember that fireproof materials are considered flammable despite their fire resistance. They
can be difficult to set on fire, but they also burn.
42