Kratki UMBRELLA Instructions D'installation Et D'utilisation page 33

Les langues disponibles

Version

Umbrella

Umbrella / BS

INSTALLATION - INTRODUCTION

Connection of a gas garden heater to liquefied gas cylinders, as well as its adjustment and

checking the tightness of the installation should be made only by an authorized gas equip-

ment installer or authorized service technician in accordance with applicable regulations,

which should be confirmed on the product warranty card. Lack of such confirmation voids the

warranty!

DEVICE INSTALLATION AND STORAGE OF BOTTLES SHOULD BE IN COMPLIANCE WITH APPLI-

CABLE LAWS

NEVER USE ANY PARTS OF THE APPLIANCE NOT PROVIDED OR RECOMMENDED BY THE MANU-

FACTURER!

The device has an open combustion chamber without the option of connecting it to a chimney flue.

The UMBRELLA gas garden heater is sold with the pre-installed gas control system, however, before

the first use it is recommended to check the tightness of the system due to the possibility of its unse-

aling in transport. All instructions on how to properly connect the system, installation in the table and

frame can be found below in the following instructions.

NOTES ABOUT HANDLING:

This device is designed for easy installation and it is movable using the grips on sides of the

appliance. Before moving it, make sure that all anti-removal components have been uninstalled,

the gas supply has been cut off, and the hose is disconnected from the heater valve. Moving the

device while it is in operation is strictly prohibited. After placing the heater in the desired place,

secure it against slipping, falling out or falling over.

WARNING: DO NOT MOVE THE APPLIANCE WHEN IT IS IN OPERATION!

All European type GAS cylinders up to 11 kg weight and not wider than 33 cm or higher than 65 cm

are compatible with the appliance.

Umbrella/bs