Adjustment - Jay ROHO DRY FLOATATION Supplément Au Manuel De L'utilisateur

E NG LI S H
A. ADJUSTMENT
1. Open the air valve by twisting it counterclockwise. If your cushion comes with two
valves, open both valves using the same technique. (Figure 7)
2. Attach the rubber hose on the ROHO
cushion insert with the pump until just before the cushion begins to arch. (Figure 8)
3. Remove the pump hose from the valve and close it by twisting it clockwise. (Figure 9)
4. Sit on the JAY Fusion Cushion, with the ROHO
in your normal sitting position with armrests and footrests properly positioned.
5. Slide your hand beneath your buttocks to locate your lowest bony prominence, usual-
ly the ischial tuberosites. If necessary, your clinician or caregiver should assist you.
(Figure 10)
6. Leaving one hand in place beneath the lowest bony prominence, use the other hand
to open the valve. As air is released from the cushion insert, you will begin to sink
into it. When your fingertips touch its base, close the valve. Approximately 1/2" (13
mm) of air should be between your lowest bony prominence and the base of the
cushion. (Figure 11)
B. IMPORTANT ADJUSTMENT NOTES
• Your JAY Fusion Cushion with ROHO
ordered with two valves, one on each side of the cushion. If you have two valves,
steps 1-6 above should be repeated for each valve. Two valves indicate that your
cushion insert is divided in the middle. You, your clinician or caregiver should locate
the lowest bony prominence on the same side as the air valve used to adjust the cush-
ion.
• You, and your clinicians or caregivers should check the cushion insert daily to ensure
that you have not bottomed out (ie. lost air and are now sitting on the base of the
cushion). If you have bottomed out, the protective value of the cushion insert is lost.
You should also check to be sure the cushion insert is not over-filled with air. The
cushion insert will work best with approximately 1/2" (13mm) of air between you and
its base.
• The ROHO ® DRY FLOATATION
may have to repeat steps 1-6 above as you change altitudes.
124610 Rev. A
® Pump to the end of the valve. Inflate the
DRY FLOATATION
®
DRY FLOATATION insert may have been
® ®
® insert may be affected by changes in altitude. You
insert installed,
®
4
ADJUSTME NT
7
8
9
10
11