Milwaukee 6310-20 Manuel De L'utilisateur page 8

Cutting Large Panels (Fig. 12)
Large panels and long boards sag or bend if they are not correctly
supported. If you attempt to cut without leveling and properly supporting
the workpiece, the blade will tend to bind, causing KICKBACK.
Support large panels. Be sure to set the depth of the cut so that you only
cut through the workpiece, not through the supports.
Fig. 12
Ripping Wood
Ripping is cutting lengthwise with the grain. Select the proper blade for
your job. Use a rip fence for rips 4" wide or less. To install the rip fence,
slide the bar through the rip fence slot in either side of the shoe. The
width of the cut is the distance from the inside of the blade to the inside
edge of the rip fence. Adjust the rip fence for the desired width, and lock
the setting by tightening the rip fence adjusting knob.
When ripping widths greater than 4", clamp or tack 1" lumber to workpiece
and use the inside edge of the shoe as a guide.
Cross-Cutting Wood (Fig. 13)
Cross-cutting is cutting across the grain. Select the proper blade for
your job. Advance the saw slowly to avoid splintering the wood.
Fig. 13
To reduce the risk of electric shock, check work area for
hidden pipes and wires before making pocket cuts.
Pocket Cutting (Fig. 14)
Pocket cuts are made in the middle of the workpiece when it can not be
cut from an edge. We recommend using a Sawzall
jig saw for this type of cut. However, if you must use a circular saw to
make a pocket cut, USE EXTREME CAUTION. To maintain control of the
saw during pocket cutting, keep both hands on the saw (Fig. 14).
1. Beginning at a corner, line up the sight line with your cutting line. Tilt
the saw forward, firmly fixing the front of the shoe on the workpiece.
The blade should be just above cutting line, but not touching it. Raise
the lower guard using the lower guard lever.
page 8
WARNING!
® reciprocating saw or
APPLICATIONS
2. To start the saw, push the lock-off button down while pulling the
trigger. Allow the motor to reach full speed before beginning cut.
Using the front of the shoe as a hinge point, gradually lower the
back end of the saw into the workpiece. Release the lower guard
lever and grasp the front handle.
Fig. 14
3. When the shoe rests flat against workpiece, advance the saw to
the far corner. Release the trigger and allow the blade to come to a
complete stop before removing it from workpiece. Repeat the above
steps for each side of the opening. Use a Sawzall
saw, jig saw or small hand saw to finish the corners if they are not
completely cut through.
To reduce the risk of injury, always remove battery pack
before attaching or removing accessories. Use only
specifically recommended accessories. Others may be
hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric
Tool catalog or go on-line to www.milwaukeetool.com. To obtain a
catalog, contact your local distributor or a service center.
Thin Kerf Blades
Special thin kerf blade designed for cordless circular saws.
24 Tooth Blade
Cat. No. 48-40-4108
40 Tooth Blade
Cat. No. 48-40-4112
Blade Wrench (Allen)
Cat. No. 49-96-0080
Blade Wrench
Cat. No. 49-46-6205
Rip Fence
Cat. No. 49-22-1001
ACCESSORIES
WARNING!
®
reciprocating