HIKOKI VB 3616DA Mode D'emploi page 16

English
5. Removing and inserting the battery cover and
battery (Fig. 5)
WARNING
Make sure the battery cover is attached when operating
the tool.
Iron fi lings in the battery terminal area may result in
malfunction.
6. Remaining battery indicator (Fig. 6)
PICTGRAPH ILLUSTRATION AND EXPLANATION
Warning label (Cutting)
Warning label (Bending)
Warning label (Battery Cover)
Avoid bringing your hand near to the reaction stoppers during operation; otherwise,
you may get your fi nger caught in or may run the hazard of other injuries.
During cutting work, securely hook the rebar to the reaction stoppers. Furthermore,
secure enough length of a rebar to be hooked to the reaction stoppers.
Never bring your hand close to the cutter during operation.
Continued use of a worn-out cutter can result in the damage and the broken pieces
fl ying around. Replace it with a new cutter after approximately 8000 times of cutting
as a rough guide.
If the grip rubber gets worn out, there is a fear that it cannot suffi ciently hold the rebar
and gets broken down with its parts fl ying around, etc.
If the grip rubber cannot hold the rebar much longer, replace it with a new grip rubber.
Set the rebar in the center or the recess of the cutter during cutting work. Any cutting
work with the rebar set on corners or ends of the cutter can result in the pieces of
broken rebar fl ying around or the damage to the cutter and the machine.
If you bend the rebar with a large angle while placing your hand onto it, there is a fear
of getting your hand caught in by the fold-back reaction of the rebar.
Begin operation only after ensuring that there are no people within the turning range
of the material to be bent.
Attach the battery cover when storing or operating the tool.
16