Operating Mode; Sigma Mode (Presence Of Master Clock Sigma); Autonomous Mode (No Master Clock Sigma); Control Box Extension - Bodet Harmonys 907760 Notice D'utilisation Et D'installation

III - Operating mode
The setting of the SIGMA and AUTONOMOUS modes is accomplished by means of the control
box embedded web server (Cf. page 21).
Note: refer to the manual 607726 for further explanation of the different modes.

3.1 SIGMA mode (presence of master clock Sigma)

Control box in SIGMA mode allows :
- manually Start/Stop melodies.
- Enable/disable relays.
- Enable/disable programming.
All actions taken from the control box transit via the master clock Sigma. The control commands
are stored in the master clock, there is no disruption in the event of power failure.

3.2 Autonomous mode (no master clock Sigma)

Control box in AUTONOMOUS mode allows :
- Manually Start/Stop melodies.
If no master clock Sigma, control box sends a command directly to the Harmonys.

3.3 Control box extension

To increase the number of manual controls, it is possible to add a control box extension.

3.4 Factory settings

To configure the product to its factory settings, press buttons 1 and 4 on the power box buttons
(up to 5 minutes after power-up). To check the product returned to the factory configuration, the
two LEDs are illuminated briefly.
The default configuration is as follows :
- Name : BODET-MAC address.
- IP configuration by DHCP.
- Multicast synchronisation.
- Sending address : 239.192.54.11
- Mode : independant.
19