Control Box Extension - Bodet Harmonys 907760 Notice D'utilisation Et D'installation

5/ Connect the Ethernet network cable to the RJ45 connector.
Ethernet cable category: 5 or 6.
The broadcast mode will have to be selected in the Network configuration page of the
embedded web server (see page 19), in Multicast mode the address of the product must be the
same than that of the server (by default 239.192.55.1). Record the MAC address (identification
label on the back of the product) of the product, it will be useful during its detection by the Sigma
software in order to rename it.
6/ Close the housing by tightening the 4 screws (A).

2.2 Control box extension

The control box extension is mechanically identical to the control box so is its installation (refer
to page 16).
Note: anticipate the routing of the cable linking both boxes through the top or rear when mounting
the box to the wall.
Warning: the control box extension should be installed within 10 cm of the control box. We
recommend installing the boxes very close to each other (distance less than 1 cm).
1/ Open control box extension.
2/ Connect the linking flat cable to the connector on the card control box (see illustration
below).
Example :
18
Connection on the circuit board of control box
Wire molding