Upkeep, Storage And Calibration - VISIOMED Bewell Connect MyThermo Pocket Mode D'emploi

9. UPKEEP, STORAGE AND CALIBRATION

UPKEEP:
1. Remove any spots from the unit with a soft, dry cloth. For stubborn
spots, clean the unit with a wrung cloth after soaking in water or a
neutral solvent, then wipe with a soft, dry cloth.
2. Clean the infrared sensor as follows: wipe the surface thoroughly with a
pad, a soft cloth slightly moistened with 70 ° alcohol. The thermometer
can be used once the alcohol is completely evaporated.
3. Do not clean the infrared sensor with a tissue or paper towel that may
cause scratches and therefore incorrect results.
4. Do not use other chemical reagents to clean the lens.
5. Do not immerse the device in any liquid.
6. Do not clean the display of the device with alcohol.
7. Do not use benzene, thinner, gasoline or other strong solvents to clean
the unit.
8. Do not use ultrasonic cleaning to clean the unit.
9. To disinfect, use a cotton swab or a soft dry cloth soaked in 70%
alcohol to clean the unit.
10. If you do not use the device for a long time, it is recommended to
clean the unit one time each month.
STORAGE:
1. Do not expose the thermometer to direct sunlight, extreme
temperatures conditions (T° > 60°C or T° < -20°C), or under conditions
of high humidity (above 95%), dust, near fire or high concentrations
of salt in the air; do not subject it to inclinations, vibrations or direct
impacts; Preservation of chemicals or the presence of corrosive gases.
2. Remove the batteries from the housing if you do not plan to use the
unit over a long period.
CALIBRATION:
This thermometer is pre-configured at the factory. If the operating
instructions are followed, a re-calibration is not necessary. If you have
doubts about the accuracy of temperature readings, please contact your
retailer.
Do not disassemble the thermometer yourself - this will void your
warranty.
BewellConnect - BW-MTX1 - User Manual - 2018-06_V1 29