PIONEER DJ DDJ-RX Mode D'emploi page 8

Effect section
1
3
1 Effect parameter controls
Adjusts the beat FX parameter.
2 RELEASE FX control
Turn:
Switches the types of release FX.
Press:
The release FX is on while the control is pressed.
! If the release FX turns on, the beat FX in the same effect unit
turns off.
[SHIFT] + turn:
Adjusts the beat FX time parameter.
Rear panel
1
1 MASTER OUT 1 terminals
Connect powered speakers, etc., here.
2 MASTER OUT 2 terminals
Connect to a power amplifier, etc.
3 BOOTH OUT terminals
Output terminals for a booth monitor, compatible with balanced or
unbalanced output for a TRS connector.
4 MIC2 terminal
Connects a microphone here.
5 CD terminals
Connect to a DJ player or other line level device.
6 PHONO/LINE input terminals
Connect a phono level output device (analog player (for MM car-
tridges), etc.) or a line level output device (DJ player, etc.) here.
Switch the terminals' function according to the connected device
using the [INPUT SELECT] switch on this unit's front panel.
7 SIGNAL GND terminal
Connects an analog player's ground wire here. This helps reduce
noise when the analog player is connected.
8 MIC1 terminal
Connects a microphone here.
9 Kensington security slot
a USB terminal
Connect to a computer.
b STANDBY/ON switch
This switches this unit's power between on and standby.
8
En
1 1 2
3 3 4 5
2 3 4 5
[SHIFT] + press:
Switches the beat FX mode.
3 Effect parameter buttons
Turns the beat FX on and off or switches the parameters.
[SHIFT] + press:
Switches the types of beat FX.
4 BEATc button
Decreases the beat fraction for synchronizing the beat FX effect
sound each time the button is pressed.
[SHIFT] + press:
Sets the beat FX tempo mode to the BPM auto mode. The
track's BPM value is used as the basis for the effect's tempo.
5 BEATd button
Increases the beat fraction for synchronizing the beat FX effect
sound each time the button is pressed.
[SHIFT] + press:
Sets the beat FX tempo mode to the BPM tap mode. The BPM value
used as the basis for beat FX is calculated by the interval at which
the button is tapped.
6 7 6 5
c DC IN terminal
Connect to a power outlet using the included AC adapter (with the
power plug mounted).
d Cord hook
Catch the AC adapter's power cord and USB cable on this hook
when using this unit.
8 9 a b c d