Blade Cutting Depth - Husqvarna FS 3500 G Manuel D'utilisation

3 Move the blade guard lock forward until it stops and
unlatches. Lift the blade guard with its handle off the
support spade.
1
2

Blade cutting depth

This saw is equipped with a Blade Depth Indicator which
indicates the depth at which the blade is cutting. This saw also
includes a Blade Depth Stop which stops the cutting depth of
the blade at a specific depth.
For more information about maximum cutting depth for
different blade sizes, see section "Blades"
Use of the Blade Depth Indicator
NOTICE! Only saw as deep as the job specifications require
since deeper sawing can cause structural strength
problems.
• If the engine is running, turn the Engine start switch to the
OFF position to stop the engine.
• Turn the engine start switch to the ON position.
• Lower the saw by pushing the Raise/lower switch on the
Forward/Reverse control lever downwards until the blade
touches the surface to be cut. This will be the reference
point.
OPERATING
3
• Rotate the Blade Depth Indicator knob to the zero
position. The blade cutting depth will now be indicated on
the Depth Indicator when the blade is lowered into the
cutting surface.
– 19
English