Moving The Machine - Husqvarna FS 3500 G Manuel D'utilisation

• Set handle to most comfortable working length. Tighten
the locking knob.
A
B

Moving the machine

Prior to moving the machine, read and understand section
"Starting and stopping".
Moving the machine with the engine off
• Turn Engine start switch to "RUN" position.
Raise the saw by pressing up the Raise/lower switch on the
Forward/Reverse control lever until the blade (if installed)
clears the pavement surface.
• Put Forward/Reverse control lever into the Stop/Neutral
position.
• Pull freewheel lever on control panel to its highest
position.
16 –
English
OPERATING
• The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
!
Moving the saw with the engine on
• Raise the saw by pressing up the Raise/lower switch on
the Forward/Reverse control lever until the blade (if
installed) clears the pavement surface.
!
• Set the Water safety switch to the OFF position.
• Put the Forward/Reverse control lever into the Stop/
Neutral position. The engine will not start unless the lever
is in the Stop/Neutral position.
• Pull out the Engine Choke (A).
WARNING! Do not attempt to push the saw
while it is in neutral position on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.
WARNING! Never transport the machine
outside the cutting area with engine on and
with a blade installed.
A