Husqvarna FS 3500 G Manuel D'utilisation page 27

Daily Maintenance
WARNING! Switch off the engine before
!
carrying out any checks or maintenance.
Check engine oil level without blade and the saw horizontal for
a flat saw level.
• Check the engine oil level.
• Make sure the level is between the limits.
max
min
Check blade guard for damage
• Check the blade guard for cracks.
• Never use a broken or damaged blade guard.
Check all hoses and clamps for damage or
looseness.
The image only shows some of the hoses and clamps.
MAINTENANCE AND SERVICE
• Look for leakage on fuel and hydraulics system. Tighten or
replace as necessary.
Check air cleaner restriction indicator.
• Check and clean the outer air filter if the air cleaner
indicator is red, remove the rear cover by opening the 2 air
filter housing clamps and pulling the housing off.
• Clean the filter by blowing the element from inside out.
Use the lowest possible air pressure to remove the dust
without damaging the element.
Use 42-47 PSI (0,29-0,49 MPa;3,0-5,0 kgf/cm
compressed air to remove particulates.
• Replace any damaged filters or gaskets and check air
hose and clamps for damages or looseness. Tighten or
replace as required.
NOTICE! No need to clean the inner filter on a daily basis.
The 2 air filter housing clamps can not be closed unless the
outer air filter is properly installed.
Protection covers
• Make sure all protection covers are in place and in good
condition.
For more information, see the "Machine's safety equipment"
section.
2
)
– 27
English