Télécharger Imprimer la page

Pentair OMNIFILTER BF55 Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

OPERATING SPECIFICATIONS
Flow Rate:
Pressure Range:
Temperature Range:
PRECAUTIONS
Carefully read and follow instructions.
WARNING:
Risk of electrical shock. If your water pipes are used
to ground your home's electrical system, install a No. 8 AWG jumper
wire (or larger) around the filter. The jumper wire must be connected
at both ends by a pressure wire fitting or other connection that
satisfies NEC or CEC and local codes. Consult a building inspector or
licensed electrician for more information.
WARNING:
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before or after
the system.
CAUTION
Filter must be protected against freezing, which can
cause cracking of the filter and water leakage.
CAUTION
The rubber O-ring provides the water-tight seal between
the cap and the bottom of the housing. It is important that the O-ring
be properly seated in the groove above the threads of the housing or
a water leak could occur.
CAUTION
Because of the product's limited service life and to
prevent costly repairs or possible water damage, we strongly
recommend that the bottom of all plastic housings be replaced every
five years for clear and every ten years for opaque. If the bottom of
your housing has been in use for longer than this period, it should be
replaced immediately. Date the bottom of any new or replacement
housing to indicate the next recommended replacement date.
CAUTION
Do not use electrical heating tape on this unit.
INSTALLATION INSTRUCTIONS
NOTE:
• Please read all instructions, specifications, and precautions before
installing and using this filter.
• For installation on standard 1-inch main copper water line.
• Use only plumber tape for fitting housing connections.
• Install filter cartridge in filter housing according to the filter
cartridge replacement instructions (below) before proceeding
with installation. See Filter Cartridge Selection Guide on page 5 to
determine the best cartridge for your filtration needs.
• Install filter after water meter or pressure tank.
• Numbered diagrams correspond with numbered steps.
1. Apply about three wraps of plumber tape in clockwise direction
to pipe threads of each fitting.
NOTE: If using mounting bracket, be sure to insert fittings or pipe
through bracket before threading into filter cap.
NOTE: Allow 1-1⁄2-inches clearance below housing to enable
filter cartridge changes.
2. Assemble all fittings into cap by hand. Use a wrench to tighten
firmly.
DO NOT OVER-TIGHTEN.
• 2 •
20 gpm
30–90 psi
40°–100°F
NOTES:
• For cold water use only.
• The contaminants or other substances removed or reduced by this
water treatment device are not necessarily in your water. Ask your
local water municipality for a copy of their water analysis, or have
your water tested by a reputable water testing lab.
• Filter cartridge life varies depending on filter type, usage, and water
conditions.
• The replacement filter cartridge used with this system has a limited
service life. Changes in taste, odor, or flow of the water being
filtered indicate that the cartridge should be replaced.
• Use only OMNIFILTER replacement cartridges.
• This installation must comply with all applicable state and
local regulations.
• Use only Plumber tape without adhesive backing to seal joints. Do
not use pipe compound (pipe dope), sticks, or similar compounds
with this unit; they contain petroleum derivatives which will cause
crazing and cracking of the plastic in the filter housing.
• Use only soap and water to clean filter housing and components.
• After prolonged periods of non-use, such as a vacation, it is
recommended that the system be flushed thoroughly. Let water run
for 5–6 minutes before using.
• Do not use a torch near the unit.
• An activated carbon cartridge may contain a small amount of
carbon fines (very fine black powder). A new cartridge, after
installation, should be flushed with sufficient water to remove the
fines before using the water.
• Wear safety glasses during installation.
1
2
Valve
Union

Publicité

loading

Ce manuel est également adapté pour:

Omnifilter bf56