Haussmann MJ2630II Guide De L'utilisateur page 46

Center cover
Screw
Outer flange
Blade
fig.36
fig.37
Spindle lock
Inner flang
fig.38
Arrow
Blade
fig.39
MAINTENANCE
INSTALLING OR REMOVING SAW BLADE (fig. 36-39)
• Always be sure that the tool is switched off and unplugged before installing or
removing the blade.
• Use only the wrench provided to install or remove the blade. Failure to do so may
result in over tightening or insufficient tightening of the screw. This could cause
Wrench
an injury.
• To remove the blade, use cross screwdriver to loosen the screw holding the center
cover and loosen the screw, but don't remove it. Turn the center cover counter-
clockwise and raise the blade guard. Press the spindle lock to lock the spindle
and use the wrench to loose the screw clockwise. Then remove the screw, outer
flange and blade. (fig. 36 & 37)
NOTE: When the inner flange is removed mistakenly, be sure to install it on the
spindle with its protrusion facing the motor. (fig. 38)
• To install the blade, mount it carefully onto the spindle, making sure that the
direction of the arrow on the surface of the blade matches the direction of the
arrow on the blade guards. (fig. 39)
• Install the outer flange and screw, and then use the wrench to tighten the screw
securely counterclockwise while pressing the spindle lcok.
AFTER USE
After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep
the blade guard clean according to the directions in the previously covered section
entitled "Blade guard" Lubricate the sliding portions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you fully.
45