SEVERIN KS 9833 Mode D'emploi page 19

unit is now defrosting, and the resulting melt-water is collected in the drain channel.
- To ensure proper drainage of the melt-water, keep the drain channel and discharge
opening in the cabinet free from any obstruction or blockage. A suitable pointed object
can be used for clearing or removing a blockage.
- After defrosting, turn the temperature control back to its operating position.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are
caused by:
- the electric motor within the compressor assembly; during
compressor start-up the sound level will be slightly higher for
a limited period of time.
- the cooling agent flowing through the circuit.
The following table lists possible malfunctions, their probable causes and solutions. In the
event of operational problems, check first whether a solution can be found using this table. If
the problem persists, disconnect the appliance from the mains power and contact our
Customer Service Department.
19