Voltage Measurements - BEHA UNITEST CHB 7 Mode D'emploi

Correct current measurement
The measurement is not correct, the reading will be zero,
because the sum of all currents is zero (Kirchhoff's 1st. Law).
However, with this circuit and a sensitive clamp meter (for example,
the UNITEST Leakage Current Clamp Meter CHB 3, Order No.
93481), the leakage current of a machine can be measured.

4.3 Voltage measurements

Do not connect more than 600 V AC or 600 V DC to the
input sockets. Exceeding these values can endanger the
operator, and may result in damage to the instrument.
Before switching to a new function, disconnect the probes
from the UUT.
23