Philips SC2004 Mode D'emploi page 27

Problem
The 'ready to lash' light is
green but the appliance
does not produce a lash
when I press the lash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1
when I switch it on.
The appliance produces a
strange smell.
The skin feels more
sensitive than usual
during treatment.
I experience an
unacceptable pain
sensation when I use the
appliance.
Possible cause Solution
The appliance To reset the appliance, switch off the appliance and
switch it on again. If the 'ready to lash' light is green
needs to be reset.
but the appliance still does not produce a lash when
you press the lash button, contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre.
This is normal. No action required.
The appliance To reset the appliance, switch it off and on again. If the
needs to be reset. appliance still does not show light intensity 1, contact
your Customer Care Centre, your Philips dealer or a
Philips Service Centre.
The attachment Clean the attachment carefully. If you are unable to
and/or the ilter
clean the attachment properly, contact the Consumer
glass is dirty. Care Centre in your country, your Philips dealer or a
Philips service centre to replace the attachment.
You have not If there are hairs on the area to be treated, these
shaved the area hairs may get burnt when you use the appliance. As
to be treated a result, you notice a strange smell. Shave the area to
properly. be treated properly before you use the appliance. If
shaving causes skin irritation, trim hairs as short as
possible and use a comfortable setting.
The strange smell disappears after a few lashes.
You stored the
appliance in a
dusty environment.
The light intensity Check if you have selected the right light intensity. If
you use is too high. necessary, select a lower light intensity.
You did not shave Shave the areas to be treated before you use the
the areas to be appliance. If shaving causes skin irritation, trim hairs as
treated. short as possible and use a comfortable setting.
The UV ilter If the UV ilter of the light exit window is broken,
of the light exit do not use the appliance anymore. Contact the
window is broken. Consumer Care Centre in your country, your Philips
dealer or a Philips service centre.
The appliance is Contact the Consumer Care Centre in your country,
defective. your Philips dealer or a Philips service centre.
You did not shave Shave the areas to be treated before you use the
the areas to appliance. If shaving causes skin irritation, trim hairs as
be treated short as possible and use a comfortable setting.
ENGLISH
27