Philips SC2004 Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
26
Problem
I have switched on the
appliance but I cannot
increase or decrease the
light intensity.
The 'ready to lash' light
does not go on when I
place the appliance on
the skin.
The 'ready to lash' light
does not go on when I
place the attachment on
my skin, but the cooling
fan works.
Possible cause
Solution
Make sure the adapter is inserted properly into the
The adapter is not
inserted properly
wall socket and/or the small plug is inserted properly
into the wall
into the appliance socket.
socket and/or the
small plug is not
inserted properly
into the appliance
socket.
The appliance is
Contact the Consumer Care Centre in your country,
defective.
your Philips dealer or a Philips service centre.
The appliance has
To reset the appliance, switch off the appliance and
to be reset.
then switch it on again. If you still cannot adjust the
light intensity, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
You have not put
Place the appliance at a 90° angle onto the skin in such
the attachment
a way that all contact switches touch the skin. Then
check if the 'ready to lash' light is on and press the
with safety ring
lash button.
properly on the
skin.
If this does not work, place the appliance on a part
of your body where it is easy to establish full skin
contact, for example on your lower arm.Then check
if the 'ready to lash' light works. If the 'ready to lash'
light still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
The safety ring is
Clean the safety ring carefully. If you are unable
dirty.
to clean the safety ring properly, contact the
Consumer Care Centre in your country, your Philips
dealer or a Philips service centre to replace the
attachment.
The overheat
When the overheat protection has been activated,
protection has
the fan still works. Do not switch off the appliance
been activated.
and let it cool down for approx. 15 minutes before
you continue to use it. If the 'ready to lash' light still
does not go on when you place the appliance on
the skin, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sc2004/11Lumea sc2004Lumea sc2004/11

Table des Matières