Philips SC2004 Mode D'emploi page 18

ENGLISH
18
6 Press the safety ring fully onto the skin with slight pressure.
Note: The safety ring has contact switches that together are the safety system
of the appliance. This safety ring prevents unintentional lashing without skin
contact.
, The 'ready to lash' light on the back of the appliance lights up green
when all contact switches of the safety ring are in contact with the
skin and the device is charged. This may take a few seconds.
Tip: For easier use, stretch the area of skin you want to treat. On areas with
softer skin, you may need to exert more pressure on the appliance to push in
all contact switches.
Press the lash button to release a lash. Now you have 2 options to
7
release the next lash:
A Keep the lash button pressed. The appliance releases one lash
after another as long as the safety ring is in full contact with the skin.
Immediately after the appliance has lashed, slide the appliance to the
next area. Make sure the safety ring is fully pressed onto the skin.
This 'Slide & Flash mode' is especially convenient for treatment of larger
areas like the legs.
B Let go of the lash button after each lash. For the next lash, place the
appliance on the area right next to the previously lashed area. Make
sure the safety ring is fully pressed onto the skin.
This 'Step & Flash mode' guarantees a precise treatment of e.g. the knees
or ankles.
Note: After a few seconds, the appliance is ready to lash again, so make sure
that you move it to the next area immediately after it has lashed.
Do not treat exactly the same area multiple times during one session.
This does not improve the effectiveness of the treatment, but increases
the risk of skin reactions.
Note: The visible light produced by the appliance is the relection of the lash
on the skin and is harmless to your eyes. It is not necessary to wear goggles
during use.