Zanussi ZTE7100PZ Notice D'utilisation page 19

WARNING!
It is important not to connect the
vent hose to, for example, a cooker
hood, or a chimney or flue pipe
designed to transmit the exhaust
from a fuel burning appliance.
Note that to prevent condensation problems, it
is essential that the dryer be installed with the
flexible hose to transmit its "exhaust" at least
beyond the kitchen units; preferable outside the
kitchen. In order to prevent the appliance from
overheating, it is important that the steam
exhaust is unobstructed. Thus, if a permanent
hose installed to an external wall or ceiling, it
must be ensured an exhaust capacity of
minimum 150 m3/h. If the dryer is installed
adjacent to kitchen units, make sure that the
vent hose is not squashed. If the hose is not
fully squashed, drying efficiency will be
decreased , resulting in longer drying times and
higher energy consumption. If the hose is fully
squashed, the automatic cut-outs with which
the appliance is fitted can operate. When
operating the tumble dryer, the room
temperature must not be lower than +5°C and
higher than +35°C, as it can affect the
performance of the appliance.
If the hose is long and the room
temperature low, the moisture might
condense to water inside the hose.
This is an usual occurrence. To
prevent this water from the hose, it is
recommend to drill a small hole (via.
3 mm) in the lowest point of the
hose and to put a small container
below it. (See picture, point B).
www.zanussi.com
B
There are 3 vent outlets: on the left,
right side and at the rear.
1
A
Pull the ring nut A
1
from the vent outlet at
the rear.
The not used vents
3
must be sealed with
supplied covers.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed.
WARNING!
The door must only be reversed by
an authorised service engineer.
Please contact your Authorised Service Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
• stack kit
Available from your Authorised
Service Centre or your specialist
dealer
To enable the mounting of the dyer on top of
a front loading washing machine with cover's
depth between 48 and 60 cm.
Read carefully the instructions supplied with
the kit.
2
A
Screw on the ring nut
2
to the hose and push
it into position.
19