Connecting A Playback Device Using A Cinch Cable; Pairing The Device With A Bluetooth Playback Device - SilverCrest SSTB 10 A1 Mode D'emploi Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44

Connecting a playback device using a cinch cable

Connect the audio input jacks R and L
an audio cinch cable with the corresponding audio output sockets on the
external audio device. Make sure that the red and white colour markings
correspond.
To switch on the device, press the
Press the FUNCTION button
the remote control repeatedly until
Switch on the connected playback device and start playback.
NOTE
If both the AUX 1 socket
external playback devices, the music will be played back via the AUX 1
socket
3.5 mm jack cable from the AUX 1 socket
Pairing the device with a Bluetooth
To play audio files via Bluetooth
paired with a compatible Bluetooth
Press the
Press the FUNCTION button
once to activate the Bluetooth
and the flashing
Set up the Bluetooth
Bluetooth
found in the operating instructions for your Bluetooth
Select the entry SSTB 10 A1 from the list of found devices on your
Bluetooth
to connect the two devices. If the pairing is successful, you will hear a
signal and the
32 
GB │ IE
and the AUX 2 socket
by default. To use the AUX 2 socket
button (
or
) to switch the device on.
icon indicates that the device is ready for pairing.
®
playback device so that it searches for other
devices. A detailed description of how to do this can be
®
playback device and, if required, enter the code "0000",
®
icon appears on the display
on the rear of the device using
button (
or
on the device or the AUX button
appears on the display
are connected to
, simply disconnect the
.
®
playback device
, the device must previously have been
®
playback device.
®
on the device repeatedly or the
function.
appears on the display
®
.
).
on
.
button
playback device.
®
SSTB 10 A1

Publicité

Table des Matières
loading

Table des Matières