Beurer GS 42 Mode D'emploi page 14

The setting to be changed will flash each time.
• To change a setting, press the buttons
• To save the setting and move onto the next one, or to close the setting, press the SET button.
The scale will switch off automatically after this procedure.
The scale will also switch off if no buttons are pressed for more than 15 seconds.
Setting user data
The scale comes equipped with 10 locations for storing user data and space for more than 10
measurement values per user. You and, for example, the members of your family can save and
later access the following personal settings in the storage locations:
Sequence
1
2
Switch on the scale (see 7. Switch on the scale). When "0.0 kg" is displayed:
• Press the 'USER' button until you have reached the desired memory space. After the display
shows the preset body height "0.0 kg" will appear.
• To change the body height press "SET".
• Press the and
• Finish entering data by pressing the SET button.
uSeR
kg
2 sec
Please note: if you change the height value at a later date, all measurement data
saved in your storage location up until that point will be deleted.
9 Operation
Weighing yourself and calculating BMI
To weigh yourself and to calculate your personal body mass index:
• Switch on the scale (see 7. Switch on the scale).
• Then select the storage location where your settings have been saved using the 'USER' button.
Next, your saved height value will be displayed. Wait until "0.0 kg" is displayed again. You can
now use the scale. Stand still whilst weighing yourself.
User data
Memory position
Body height
buttons to set your height. Keep button pressed for quicker run.
and .
3 sec
Set
kg
14
Parameters
1 to 10
100 to 220 cm
(3'-03" to 7'-03")
cm
Set
cm