geo-FENNEL FL 550H-G Mode D'emploi page 27

EN
REMOTE CONTROL CHANNEL
Press the button short to select the remote control channel (circularly from CH1 to CHF9 = 9 channels).
The channels of the remote can be changed in order to avoid that several units on one construction site
disturb each other.
REMOTE CONTROL
When the remote control is switched on the display automatically shows „CH1". With the button the
channels of the remote can be selected circularly from CH1 to CHF9 (9 channels are available).
If the display shows the remote has no connection to the instrument (the instrument is too far away,
the connection is disturbed, the channels of remote and instrument are not the same, the remote is swit-
ched off). shows that the connection between remote and instrument is okay.
With the on/off switch of the remote only the remote can be switched on and off - not the instrument.
The battery status indication of the remote only shows battery status of the remote.
The keypad of the remote is the same as the keypad of the instrument.
27