geo-FENNEL FL 550H-G Mode D'emploi page 24

TILT mode indication
EN
VWS mode indication
DISPLAY INDICATION
A) Rotating speed indication
B) Indication of the slope value of the X axis
C) Indication of the slope value of the Y axis
D) Battery status indication
MAN mode indication
E) Channel selection indication of the remote
control
F) Indication of remote control active / inactive
G) MANual function indication
H) VWS function indication
Remote status indication
I) TILT function indication
J) Area shield indication
Remote channel indication
F
OPERATION
Power the instrument on with button
After power on the instrument the display shows automatically:
- the battery status of the instrument;
- the preparation of the TILT mode (the TILT LED is blinking slowly); if the instrument is not disturbed
within 30 sec, the TILT mode is active; (see also: TILT function)
- the SLOPE status +00.000 %;
- the channel CH1 of the remote control; if a remote is active and can receive a signal the indication
= ; if no remote is active the indication is =
- WVS and MAN mode are not yet active; no display indication
At the same time the self-levelling procedure starts.
If the self-levelling procedure is completed the laser rotates with 600 rmp.
ROTATING SPEED
Press the button to select the rotating speed: 600 rpm or 1100 rpm (after power on the laser it auto-
matically rotates with 600 rpm).
AREA SHIELD FUNCTION
Press the button to shield one or more areas of the laser beam. The area shielded is shown in the
display.
Note
It is not possible to shield all four areas at the same time - one area must remain active.
24
TILT mode indication
VWS mode indication
MAN mode indication
G
F
Remote status indication
Remote channel indication
.
I
H
MAN
MAN
MAN
Area shield indication
E
Area shield indication
A
B
C
D
J
Rotating spe
indica
X axis grade
Y axis grade
Power indica