Publicité
Les langues disponibles
Les langues disponibles
User Manual
IR Control
IR Remote
1. Press once to power on the Matrix Transmitter. Press again to set the
unit to standby mode.
2. Press the required number once to select the desired input port 1-4
corresponding with the desired Output display A-D.
IR Control from the display side
To control the source device from the display side of the installation,
please connect the IR transmitter cable to the IR Tx port of the Matrix.
Please ensure the transmitter is located in front of the IR eye of the
source device. Then connect the IR Receiver cable to the IR In port of the
Receiver unit. Please ensure the Receiver is located with or close to the
display.
IR Control from the source device side
To control the display from the source device side of the installation, please connect the IR transmitter
cable to the IR In port of the Receiver unit. Please ensure the IR transmitter is in front of the IR Eye of
the display. Then connect the IR receiver cable to the IR Rx port of the Matrix unit. Please ensure the
receiver is located in a suitable position for a clear line of sight.
Operation
Please ensure all Matrix and receiver units are switched off before installation.
1. Connect up to 4 source devices to the Matrix Transmitter's HDMI input ports.
2. Connect up to 4 displays to the Matrix Transmitter's Local HDMI Output ports. Connect up to 4 of
the receiver unit's to the RJ-45 ports of the Matrix Transmitter using Cat.6 cable of up to 50m in
length.
3. Connect up to 4 displays to the HDMI port of the receiver units.
4. Connect all IR transmitters and receivers for the desired setup (For more detailed information on IR
control please see the IR Control section). Double sided adhesive tape is provided to ensure the
respective cable is fixed in place.
5. Connect the power supply to the Matrix Transmitter and power on all devices in the following
order: Source Device, Matrix, Receiver Unit's, Output Displays.
English
Publicité
