Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Front Panel
1. Front Panel Display: Indicates the active input port (1-4), when connected to each output port
IR: IR Receiver (Receivers the IR signal from the included IR remote Control)
2. Out / Enter / In: Push buttons to set the active Input or output
Out: Press once to select the output signal
In: Press once to select the input source
Enter: Press once to confirm and save the Input / Output setting
Rear Panel
1
1. Local HDMI and RJ-45 Cat.6 Output Ports: Connect to Local HDMI displays or connect to
one of the supplied Cat.6 Receiver units via Cat.6 cable.
2. HDMI Input Ports: Connect to a HDMI source device
3. IR Output Ports: Connect using the included IR Transmitter or Receiver Cables (For more detailed
information on IR control please see the IR Control section)
4. RJ-45 IP Port: Connect to an active Ethernet link for IP/Telnet control
5. RS-232 Port: Connect to a PC or control system with 9-Pin D-Sub cable to transmit RS-232
commands
6. IR Extension port: If the Matrix Transmitter is out of sight or the IR sensor on the front of the unit is
obstructed, please connect an included IR receiver to extend the range of the IR line of sight.
7. EDID Dipswitch: This dipswitch allows for full EDID Management. Please see the table below for
further information
8. Power: Connect the included 12V DC 2.5A Multi-country PSU
9. On/Off: Press to switch the Matrix transmitter On or Off
2
3
1
4
5
English
9
6
7
8
Publicité
