Turn On The Watch (First-Time Use Only); Batteries - Oregon Scientific Outbreaker Mountain-Ski Mode D'emploi

TURN ON THE WATCH (FIRST-TIME USE ONLY)

Press FUNC. / SET for 2 seconds to activate the LCD
display.

BATTERIES

The watch uses a 1 x CR2032 lithium battery, which has
already been installed. See below for battery warnings.
LOW BATTERY DESCRIPTION
ICON
The watch battery is low
- - Appears when the battery is too low
to operate the sensor. "- -" is shown
instead of temperature, altitude, UVI
and barometer readings. The bar
and line charts will also be frozen
NOTE Heavy use of the backlight, altitude alarm and
ski timer will reduce the battery service life significantly.
To replace the watch battery:
1. Locate the battery compartment on the back of the
watch.
2. Using a coin, as shown above, twist the compartment
lid counter-clockwise until it clicks out of place.
3. With your finger, remove the old battery.
4. Insert the new battery with the + side upwards.
5. Replace the battery compartment lid by twisting it
clockwise until it is firmly in place.
NOTE When you replace the batteries it is important to
re-calibrate the altitude or sea level. To re-calibrate the
watch you simply set the current altitude or sea level.
(See "Set the Altitude" or "Sea Level" section.)
5