Set The Ski Timer; Set The Auto-Stop - Oregon Scientific Outbreaker Mountain-Ski Mode D'emploi

AUTO-RELOAD
You can set the timer to automatically reload when you
reach a pre-set altitude. Therefore, when you get back to
the top of a run all you have to do is press ST to activate
the countdown timer.
To activate this function, you must turn it ON and set the
altitude reload height. The altitude reload height is relative
to the base-level height that you set in the auto-stop
feature.
AUTO-STOP
You can set the timer to automatically stop when you go
below a pre-set altitude. This means that when you are
timing a run you do not have to stop the timer manually.
To activate this function, turn it ON and set the base level
as shown in the "Set the Auto-Stop" section below.

SET THE SKI TIMER

To set the ski timer:
1. Press MODE to navigate to Ski Timer Mode. The last
countdown time will display on the screen.
Either:
2. Press ST / SP to start and stop the countdown timer.
Or:
3. Press and hold SET to enter a new countdown time.
4. Use + or - to change the setting.
5. Press SET to confirm.

SET THE AUTO-STOP

To set auto-stop:
1. Press MODE to navigate to Ski Timer Mode.
2. Press and hold SET. Then press SET until you reach
the screen below.
14