Reception Of Radio Controlled Time Signal; Signal Reception Indicator; Time And Calendar Manual Setting - Oregon Scientific EW93 Mode D'emploi

RECEPTION OF RADIO CONTROLLED TIME
SIGNAL
The time and calendar are radio-controlled. The
current time and calendar are automatically
synchronized with time signal transmitted from
Germany/England.
When used for the first time (after inserting batteries or
pressing "RESET" key), and then after 5 minutes, the
clock will start to receive the time signal. The signal
reception indicator will be flashing for 7 minutes.

SIGNAL RECEPTION INDICATOR

The wave segment flashing means time signals are
being received. The signal quality could be classified
into 3 types:
No signal Weak signal
Note
1. The unit will automatically search for the time
signal at 2:00 (3:00 or 4:00 is also available if
the signal is not received at 2:00), 8:00, 14:00
and 20:00 each day.
2. Always place the unit away from interfering
Excellent signal
6
sources such as TV set, computer, etc.
3. Avoid placing the unit on or next to metal
plates.
4. Closed area such as airport, basement, tower
block or factory is not recommended.
5. Do not start reception in moving articles such
as vehicles or trains.

TIME AND CALENDAR MANUAL SETTING

If you are out of reach of the Radio Controlled
sensor or if the reception is not reachable, the time
and calendar can be set manually. As soon as the
signal of sensor is received again, the clock will
automatically synchronize with the exact time and
calendar.
1. In normal time mode, press "SET CLOCK"
key once to enter the time setting mode.
2. Press "+/CHANNEL" or "-/MIN.MAX." key to
change the settings.
3. Press "SET CLOCK" to confirm. The setting
order is: 12/24-hr format, time, +/-23 hours
time difference, year, day/month format,
date.
4. Press "SET CLOCK" key to save and exit the
setting mode.