Change Settings; Remote Sensor; Set Up Thermo / Hygro Sensor (Rtgr328N) - Oregon Scientific BAR826HG Manuel D'utilisation

NOTE It is recommended that you use alkaline
batteries with this product for longer performance.
UNIT
Main
Remote

CHANGE SETTINGS

1. Press MODE to switch between Areas.
the selected Area.
2. Most Areas have alternate display options (for
example, Clock / Calendar). Press
options, or /
3. Press and hold MODE for 2 seconds to enter setting
mode.
4. Press or to change settings.
5. Press MODE to confirm.
P/N:086-003808-011 REV1
10/162
BAR826HG_UM_EN.P65
LOCATION
Weather Forecast Area
Temperature / Humidity Area
indicates
or to switch
to switch between clock and alarm.
9

REMOTE SENSOR

This product is shipped with the RTGR328N Thermo /
Hygro Sensor. The main unit can collect data from up to
5 Thermo / Hygro Sensors. The main unit is compatible
with the following sensors:
THGR228N, THGR328N, THR228N, THR328N,
THWR288.
(Additional sensors are sold separately. Contact your
local retailer for more information.)
The RTGR328N Sensor collects temperature and
humidity readings, and signals from official time-keeping
organizations for the radio-controlled clock.

SET UP THERMO / HYGRO SENSOR (RTGR328N)

1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The switches
are located in the battery compartment.
SWITCH OPTION
Channel If you are using more than one
sensor, select a different channel
for each sensor.
Radio Signal EU (DCF) / UK (MSF)
Format
9
2005.3.8, 11:21 AM