Unpacking And Checking The Package Contents; Preparation; Choosing The Location; Filter Shaft - Steinbach Classic 310 Notice Originale

Risk of injury through insufficient qualification!
Insufficient experience or skills for handling the required tools and insufficient knowledge of
regional or normative regulations for the required work can lead to severe injuries or material
damage.
- Assign all work whose risks you cannot estimate due to insufficient personal experience
to a qualified expert.
- Do not operate the device when impaired (e.g. under the influence of drugs, alcohol or
medication).
Improper handling of the device can damage the device.
- Select a location for the device that is protected from the weather.
- Install the filter system at a sufficient distance to the pool wall so that it cannot be used as
an aid for entering the pool.
- Ensure sufficient air exchange to prevent overheating of the motor.
- Do not let the device run dry (without water).
- Only use the supplied pump that matches your device.
- Before switching anything on the valve head, turn the filter pump off.
- Never place the device or parts of it in the pool.
- Never use flocculants in your pool water. They can cause the filter balls to clump
together.

Unpacking and checking the package contents

Packaging materials pose a risk of suffocation!
Catching your head in the packaging foil or swallowing other packaging materials can cause
death. There is a higher risk for children and mentally challenged persons who cannot
estimate the hazard potential due to lack of knowledge and experience.
- Prevent children and mentally challenged persons from playing with the packaging
materials.

Preparation

Choosing the location

The following requirements must be met or considered:
- Position the filter system between the suction connection and the injection nozzle with sufficient
distance to the pool wall so that the filter system cannot be used to climb into the pool
- Position the pump below the water level
- Maximum 3 m distance to the pool
- Stable, sturdy and horizontal surface, for example a concrete slab

Filter shaft

A filter shaft is required if the pool is partially or entirely installed in the ground so you can
place the pump of the filter system below the pool's water level.
- Make sure that the filter shaft cannot be flooded and that ambient and rainwater can drain away
easily.
WARNING!
NOTICE!
WARNING!
31