Tripp-Lite SmartOnline SU1000XLCD Manuel Du Propriétaire page 5

Features
FAULT INDICATORS
INVERTER MODE STATUS INDICATOR
Label Icons
13-03-138 93-3168-EN.indd 5
GENERAL FAULT ICON
> ON with on-screen fault or shutdown code or icon indicates a variety of UPS fault conditions.
WIRING FAULT ICON
> FLASHING indicates input power lacks ground or is not wired correctly.
SINE WAVE ICON
> ON indicates the UPS is receiving input power and is providing inverter derived AC output
> BLINKING indicates UPS is receiving input power and is providing inverter derived AC output that is frequency
independent of AC input.
BYPASS ICON
> ON indicates the UPS is running in BYPASS mode.
> ON with "ECO" icon indicates the UPS is running in ECONOMY mode.
3 DIGIT DISPLAY
The 3 digit display is designed to report a variety of UPS operating and site power related conditions.
The associated picture icons and label abbreviations help identify the information being reported.
IN
The "IN" label indicates the value reported is an INPUT condition (input voltage, input frequency).
OUT
The "OUT" label indicates the value reported is an OUTPUT condition (output voltage, output frequency).
LOAD
The "LOAD" label lights to indicate the value reported is an OUTPUT LOAD condition (load kVA, load kilowatts,
load percentage).
BATT
The "BATT" label lights to indicate the value reported is a battery related condition (battery charge %, battery
volts).
Hz
The "Hz" label lights to indicate the value reported involves frequency (input frequency, output frequency).
MIN
The "MIN" label lights to indicate the value reported involves minutes (estimated runtime).
RUNTIME
The "RUNTIME" label lights to indicate the value reported is the estimated runtime in minutes available at
the current load level.
KWA
This is a special symbol that will never light up fully (except momentarily when first plugged in). It's designed
to light up in 4 unique patterns to describe 4 possible measurement values: volts ("V"), volt amps ("VA"),
watts ("W") and amps ("A").
TEST
The "TEST" label lights to indicate the UPS is either running a self-test or reporting self-test results.
SET
The "SET" label lights during setup mode to indicate the current action involves setting a configuration item.
5
3/28/2013 1:04:46 PM