Tripp-Lite SmartOnline SU1000XLCD Manuel Du Propriétaire page 27

Internal Battery Replacement
See the following diagrams for battery removal and installation procedures.
SU1000XLCD
1a
Remove the screw from the left of the front bezel.
1b
Remove the front bezel.
2 Flip open the white connector holder. Disconnect the
connector that's inside the white connector holder.
3
Remove the screw that holds the metal bar in place (in front of
the battery compartment on the left side). Remove the metal
bar from the UPS.
4
Remove the batteries using the pull tab.
Note: Please memorize the original battery position and orientation to ensure
that you install the new batteries correctly.
5
Insert the new battery set into the UPS in the same position as
the original set.
6
Replace the metal bar. Reinstall the screw on the right side
that holds the metal bar in place.
7
Reconnect the DC connector (red-to-red, black-to-black) and
flip the white connector holder closed. Close the white
connector holder.
8
Reinstall the front bezel and replace the screw on the left of
the bezel to secure it to the cabinet.
13-03-138 93-3168-EN.indd 27
1a
1b
3
2-3
4
27
2
3/28/2013 1:05:47 PM