Uberhaus 15625003 Guide De L'utilisateur page 24

TIMER button
7
blinking. Within 5s, press + or - button to adjust the time
+ or - button once will increase or decrease the time by 0.5h. Hold + or - button
for 2s, to change increments faster. Release the button after your required set time
blinking.
blinking. Within 5s, press + or - button to adjust the time
+ or - button once will increase or decrease the time by 0.5h. Hold + or - button
for 2s, to change increments faster. Release the button after your required set time
blinking.
review the remaining time. Within 5s, press TIMER button again to cancel this
function.
8
Combination of "+" and "-" buttons: to lock/unlock the remote control
Press "+" and "-" buttons simultaneously to lock or unlock the keypad. If the remote
control is locked,"
blinks three times.
Combination of "MODE" and "-" buttons: to alternate between ºC / ºF
9
When unit is OFF, press "MODE" and "-" buttons simultaneously to switch between
℃ and ℉ .
Replacement of Batteries in Remote Control
1. Press on the tab"
controller with fingers as shown in the figure on the
right, and remove the cover along the arrow direction.
2. Replace with two AAA, 1.5V dry batteries.
Make sure positions for "+" pole and "-" pole are
correct.
3. Reinstall back cover.
Note:
● The distance between signal sender and receiving window should be no more
than 26 ft (8 m), and there should be no obstacles between them.
● The remote control's signal may be hindered by fluorescent lighting or wireless
devices; in such cases, please get closer to the air conditioner to activate the
remote control.
● Replace new batteries of the same model when replacement is required.
● When the remote control won't be used for a long time, please take out the
batteries.
Operation Guide
"will point to" ". In this case, if you press any button, "
" on back cover of remote
s set up, press TIMER button once to
Battery
Cover of battery box
23
d H icon will be
H icon will stop
H icon will be
H icon will stop
Reinstall
Remove
"