Uberhaus 15625003 Guide De L'utilisateur page 23

MODE button
2
Each time you press the button, a mode is selected in a sequence that goes from
AUTO, COOL, SAVE, FAN and DRY, as follows:
- / + button
3
● Pressing + or - button once will increase or decrease set temperature by 1°F(°C).
Hold + or - button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.
● When setting Timer On or Timer Off, press + or - button to adjust the time.(See
TIMER Button for setting details)
FAN button
4
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, , , to
NOTE: Your model of air conditioner has 3 speeds.
I FEEL button
5
Press this button is to activate "I FEEL" function. Under this function, the sensor
in remote control will send the temperature around the remote to the unit every
10min, and the unit will cycle to reach the temperature
sent by the remote. Press this button again to turn off this function.
SLEEP button
6
Press this button to activate Sleep Mode. Within 2 hours after Sleep Mode is acti-
vated, set temperature will be increased by 1℃/2
under Sleep Mode, set temperature will increase by 2℃/4 . Press this button again
to turn off the Sleep Mode. Sleep Mode is available in Cool, Energy saving and Dry
modes.
Operation Guide
AUTO COOL
then back to Auto.
Auto
Speed 1 Speed 2
SAVE FAN
Speed 3
° F
per hour. For the entire night
22
DRY
Speed 4
° F