Intended Use; Technical Data; Machine Features; Commissioning - Festool SYSLITE DUO Notice D'utilisation

English
– The device is not a toy! Keep the device
away from children.
3

Intended use

Floodlight is intended for illumination of con­
struction sites, work areas, garages and the
like. The electrical safety of the power source
must be safeguarded.
The device is not suitable for illuminating
rooms in residential buildings.
The user is liable for improper or non-in­
tended use.
NOTE Some states have additional regu­
lations for using electrical equipment on
construction sites. These national regulations
may restrict the use of the working light or im­
pose additional requirements. Observe the valid
national regulations.
4

Technical data

Flood light
Nominal voltage
Frequency
Illuminant
Max. power
Light current
Light color
Color rendering index
Lifespan (L70)
Weight
Protection type
5

Machine features

[1-1] Detachable stand, cable spool
[1-2] Luminous area
[1-3] Handle
[1-4]
Wall peg, cable clam
[1-5] Mains power cable
The specified illustrations appear at the begin­
ning of the Operating Instructions.
12
SYSLITE dUO
220 - 240 V
50/60 Hz
80 x 1,4 W Power LED
112 Watt
8000 lm
5000 K
>80
>10.000h
3,4 kg
IP 55
6

Commissioning

WARNING
Unauthorised voltage or frequency!
Risk of accidents
► Observe the specifications on the ma­
chine's name plate.
► Observe country-specific regulations.
6.1 Switching on/off
Switching on
The device's mains plug must not be in­
serted in moist environments as it does
not have the corresponding protection against
moisture.
► Insert the mains plug.
The light cone appears automatically.
Switching off
► Pull out the mains plug.
► Wind up the mains power cable on the
base [1-1]. The cable end can be hooked
onto the provided clamp [2-1].
6.2 Temperature surveillance
When exceeding the temperature limit, the de­
vice automatically reduces luminosity. If device
continually exceeds temperature limits, power
is cut off completely.
Measures for restoring luminosity:
► Pull mains plug,
► remove cause of overtemperature (i. e. ob­
structed air vents),
► reinsert mains plug.
Full luminosity is restored.
7

Setup

Always set up device with stand to keep
air vents air accessible [4-1].
Place on dry, even and stable surface. Do not
suspend device from its power cord. Electrical
hazards by overstraining the power cord may
occur. Prevent obstruction of the cooling slits
on top and bottom of the device.
Minimum distance to illuminated
0,2m
surfaces and combustible materials
0,2 m.
7.1 Set-up angle [3]
The device can be set up in three different an­
gles.