3.2.10 Run-On Function - Berbel BFB 6bT Manuel D'utilisation

Operation
Colour temperature
Requirements:
y The colour temperature of the hob
lighting is set.
D "3.2.6 Hob lighting" (page 128).
y All light sources of the extractor
hood are switched off.
Button
☞ Hold the button (> 1 second) to
switch on all light sources with full
brightness at the same time.
☞ Touch the button 1x.
☞ Touch the button again within half
a second.
The colour temperatures are
synchronised and saved.
If the button is not touched again
within half a second, the effect
lighting starts a continuous colour
cycle.
☞ Hold the button (> 1 second) to
switch off the light sources.
132

3.2.10 Run-on function

The extractor hood comes with a run-
on function. If this function is used, the
extractor hood will run for a further
10 minutes after being switched on.
In recirculated air mode, it is necessary
to use the run-on function so that
the extractor hood can remove the
remaining odours. Using the run-on
function increases the life of the filter
filling. The filter filling must be replaced at
regular intervals.
The run-on function can be switched on
manually or automatically. As delivered,
the automatic run-on function is
activated. Corresponding setting takes
place in configuration mode.
D "3.4 Configuring the extractor hood"
(page 136).
6005229_0 – 08.09.2020