Publicité
Les langues disponibles
Les langues disponibles
English
Operate with proper hand support, proper workpiece
support, and supply cord routing away from the work
area.
WARNING
It is important to support the work piece properly
and to hold the saw fi rmly to prevent loss of
control which could cause personal injury. Fig. 1
illustrates typical hand support of the saw.
A TYPICAL ILLUSTRATION OF PROPER
HAND SUPPORT WORKPIECE SUPPORT.
Fig. 1
4. Place the wider portion of the base on that part of
the work piece which is solidly supported, not on
the section that will fall off when the cut is made.
As examples, Fig. 2 illustrates the RIGHT way to cut
off the end of board, and Fig. 3 the WRONG way. If the
work piece is short or small, clamp it down.
DON'T TRY TO HOLD SHORT PLACES BY HAND!
Fig. 2
Fig. 3
6
00Book̲C3607DWA̲NA.indb 6
00Book̲C3607DWA̲NA.indb 6
5. Never attempt to saw with the circular saw held
upside down in a vise.
This is extremely dangerous and can lead to serious
accidents. (Fig. 4)
Fig. 4
6. Before setting the tool down after completing a
cut, be sure that the lower (telescoping) guard
has closed and the blade has come to a complete
stop.
7. Never touch moving parts.
Never place your hands, fi ngers or other body parts
near the tool's moving parts.
8. Never operate without all guards in place.
Never operate this tool without all guards or safety
features in place and in proper working order. If
maintenance or servicing requires the removal of a
guard or safety feature, be sure to replace the guard
or safety feature before resuming operation of the
tool.
9. Use right tool.
Don't force small tool or attachment to do the job of a
heavy-duty tool.
Don't use tool for purpose not intended —for
example— don't use circular saw for cutting tree
limbs or logs.
10. Never use a power tool for applications other
than those specifi ed.
Never use a power tool for applications other than
those specifi ed in the Instruction Manual.
11. Handle tool correctly.
Operate the tool according to the instructions provided
herein. Do not drop or throw the tool. Never allow the
tool to be operated by children, individuals unfamiliar
with its operation or unauthorized personnel.
12. Defi nitions for symbols.
V .................volts
— .................direct current
n
o ................no load speed
---/min ..........revolutions or reciprocation per minute
Hz ................hertz
A ..................amperes
13. Do not run the saw while carrying it at your side.
14. Keep all screws, bolts and covers tightly in place.
Keep all screws, bolts, and plates tightly mounted.
Check their condition periodically.
2021/06/10 16:51:40
2021/06/10 16:51:40
Publicité
